Hi I have installed the Syslog-NG 1.6.10 in Red Hat 9.0 environment, but when I test it as the following situation: Message sender --> RH9 (Syslog-NG) --> Message receiver They worked in Giga bits networks, but when I send message to receiver in 800M bps rate, the memory usage of Syslog-NG last to increase When Syslog-NG started, it used 5800k bytes of memory, and it used 8500k bytes after 1 hour. Could u give me some advice? Best Regards Cai Wang O2Micro (Chengdu) Co., Inc. TEL: 86-28-8514 6308 ext.311 www.O2Micro.com
On Wed, 2006-06-07 at 15:41 +0800, Cai Wang(CD) wrote:
Hi
I have installed the Syslog-NG 1.6.10 in Red Hat 9.0 environment, but when I test it as the following situation:
Message sender à RH9 (Syslog-NG) à Message receiver
They worked in Giga bits networks, but when I send message to receiver in 800M bps rate, the memory usage of Syslog-NG last to increase
When Syslog-NG started, it used 5800k bytes of memory, and it used 8500k bytes after 1 hour.
Could u give me some advice?
It might be used for internal memory based buffers (controlled by log_fifo_size) I currently don't know about any memory leaks after 1.6.7 (which was related to spoof-source support) -- Bazsi
participants (2)
-
Balazs Scheidler
-
Cai Wang(CD)